plasmo profileobserver/plasmo profileobserver compact
plasmo profileobserver/plasmo profileobserver compact
Geometry measurement of weld and solder seams
This what the plasmo profileobserver can do
- Fast and precise geometry measurement of weld and solder seams
- Detects deviations from the admissible weld seam geometry with great reliability and highest speed
- Detects e.g. seam cambering or concavity, edge notches, edge offset, one-sided connection etc.
- Through high resolution the detection in the tenth of a millimeter range possible at 6m/min. and above
- Also detects the dangerous pinholes or cracks, that are visible on the surface
- With laser soldering also detects those pores, that have not been reliably closed during painting
- Due to the high speed can be used parallel to the soldering robot
- Slim construction also enables the use for poorly accessible seams
This is how the plasmo profileobserver works...
The plasmo profileobserver series functions according to the principle of laser triangulation.
The image is acquired by means of a High-Speed CMOS sensor at a speed of max. 10,000 images/sec. The CMOS chip converts the recorded laser line directly into height value 3D measured values. These are forwarded to an industrial PC over an HSSI bus. In the industrial PC the evaluation of the seam geometry takes place in real-time according to parameter-settable quality characteristics.
At the end of a measuring cycle the result (IO = In Order/NIO = Not in Order), type of defect and location of defect are shown on the monitor and forwarded to the system PLC via a digital output or a bus system.
The software can be configured accordingly for the analysis of the measurement data and for the control of the measuring sequence.
With the plasmo profileobserver with the same measuring speed not only the height profile is recorded, but also a grayscale image. In the industrial PC the gray value information is evaluated in addition to the 3D information and additional quality characteristics are detected.
The image is acquired by means of a High-Speed CMOS sensor at a speed of max. 10,000 images/sec. The CMOS chip converts the recorded laser line directly into height value 3D measured values. These are forwarded to an industrial PC over an HSSI bus. In the industrial PC the evaluation of the seam geometry takes place in real-time according to parameter-settable quality characteristics.
At the end of a measuring cycle the result (IO = In Order/NIO = Not in Order), type of defect and location of defect are shown on the monitor and forwarded to the system PLC via a digital output or a bus system.
The software can be configured accordingly for the analysis of the measurement data and for the control of the measuring sequence.
With the plasmo profileobserver with the same measuring speed not only the height profile is recorded, but also a grayscale image. In the industrial PC the gray value information is evaluated in addition to the 3D information and additional quality characteristics are detected.
Detailed information - Download Data sheet plasmo profileobserver
Customer reference:
The plasmo profileobserver performs convincingly, for example on production plants in the steel industry, such as the welding of coils at Salzgitter AG in Germany.
| < Prev | Next > |
|---|